I built this guitar out of a pallet I got for free. It's all White Oak other than some pine for the bracing. It was fun!
Since some of you are asking, here are some of the inexpensive tools I use for guitars. I do this for fun and I am not wealthy so I try to find the cheapest way to keep the hobby going. I hope this list shows that you can get started without spending all your money!
Heating pad for side bending - https://amzn.to/3YSK4F3
Epoxy I used: https://amzn.to/46Z2fe3
Black pigment to tint epoxy: https://amzn.to/3TbI2w3
Fret Saw - https://amzn.to/3yHA8mT
Rabbet Bits for cutting binding channels -https://amzn.to/3yFwfPw
Feather Board - https://amzn.to/3XdRktE
Plastic Binding - https://amzn.to/3AAK1mU
Pre Cut Fret wire - https://amzn.to/4dJ9gSv
Not pre cut fret wire - https://amzn.to/4dGixLD
Fretboard Radius Sanding block - https://amzn.to/3WR7B6i
Brass hammer for frets - https://amzn.to/4dPvvX3
Fret Crowning file - https://amzn.to/3yH4u96
The worlds cheapest spoke shave - https://amzn.to/4fKkfwP
Shinto Rasp - https://amzn.to/46NtPuG
Block Plane - https://amzn.to/4fYJrzz
